jgoetz4
Apr-17-2008, 04:18 AM
Morning Folks,
I need the help of the printer gods pronto:bow I have an HP 1220 c printer that was discovered in a work site trailer. After cleaning it up and removing the dust from the inside, it looked like it needed new cartdridges. After replacing them, I did a few test prints and everything was fine, or so it seemed. It will print excellent text and graphics on standard paper. However, when you attempt to load any type of photo paper, it will not pull it in. It appears to stop just short of the print head. If you force it, it will load, but then it leaves small blank areas on a print. I have cleaned the rollers a few times, inspected the gear system, even tried to update the driver, but to no avail. Apparently HP is aware of this problem, but does not have a definitive answer. Kinda like Canon and the err 99 syndrome. If anyone has any experience with this particular model or any additional ideas that might work, I would greatly appreciate it :thumb
Thank you very much.
Have a good day :D
Jim...
I need the help of the printer gods pronto:bow I have an HP 1220 c printer that was discovered in a work site trailer. After cleaning it up and removing the dust from the inside, it looked like it needed new cartdridges. After replacing them, I did a few test prints and everything was fine, or so it seemed. It will print excellent text and graphics on standard paper. However, when you attempt to load any type of photo paper, it will not pull it in. It appears to stop just short of the print head. If you force it, it will load, but then it leaves small blank areas on a print. I have cleaned the rollers a few times, inspected the gear system, even tried to update the driver, but to no avail. Apparently HP is aware of this problem, but does not have a definitive answer. Kinda like Canon and the err 99 syndrome. If anyone has any experience with this particular model or any additional ideas that might work, I would greatly appreciate it :thumb
Thank you very much.
Have a good day :D
Jim...